Here's my problem...I never crash. I haven't had a pilot induced wreck in more than 5 years, and I think I know why.

I'm very meticulous with my planes and I use the best equipment, ie..YS and Saito engines just for starters. I end up with so much money tied up in an airframe I am too afraid of taking risks with them that would push my flying envelope. If I could only fly 1/2 as good as I do on my simulator, I would be thrilled.

Most people would say I'm an expert flyer, been doing this for almost 20 years. I can do most of the IMAC advanced maneuvers including rolling circles, I can hover and even throw in a blender once in a while. However, I seldom get lower than 50' except to land. I am looking for advice on an inexpensive 3D plane that will fly well on a two-stroke .46 and standard servos. I've never considered a profile until now, even though I've never cared for their looks. I guess I am probably not the only one that prices themselves out of getting low and dirty.

If you were in my shoes at one time, how did you get over the cost versus earth hurdle?