RCU Forums - View Single Post - ARF elevator linkage setup.
Thread: ARF elevator linkage setup.
View Single Post
Old 03-11-2003 | 10:03 PM
  #2  
Stargazer
Senior Member
My Feedback: (3)
 
Joined: Jul 2002
Posts: 255
Likes: 0
Received 0 Likes on 0 Posts
From: Pleasant View , UT
Default ARF elevator linkage setup.
Central hobbies sells a bellcrank assy. but I think its more than the cost of adding a servo.... about $60. Maybe you could make something similar? Make a Stab Joiner out of some wire? Use a carbon fibre pushrod with a dual wire out the back?
Stargazer is offline  
Reply Like