Hi Mike,

I forgot about the H9 offerings. Very good point. I'll keep it in mind too. I have been flying for 18 years, building and flying everything. Been working on 3d a lot the last two years. It's hard to hover! I'm working on controlling rudder and pitch during a torque roll. Not good, but not bad so far. I have had a 30% Carden Extra 300 - fine for IMAC but not setup for 3d. Then a Aeroworks 50cc Velox. Seems pretty good, but it was impossible to balance with DA50 at stock location. Would have required all batteries and then lead in tail. NUTS was what I thought. My current ride is a TOC1 33% Yak with 3W 80xi on can. Wow is all I can say. It is so much better than all else I figured I needed to go bigger.

I appreciate your thoughts and suggestions.

Solstice