I have a question about throttle lag on an MW54 Mk III. I am sure that I did something wrong, but not sure what it is. The engine starts fine and will eventually run up to full RPM, but it takes literally about 13 seconds for it to get to full RPM at the factory default settings. Once there it seems to be putting out full thrust. It is a little faster to ramp up from about 1/3 throttle, but is still taking longer than I know a wren should as I hear they have excellent throttle response. I reduced the "Acceleration Delay" from the default of 25 to 15 and then all the way down to 7 and it seemed to help a little, but it was still taking about 7-8 seconds to get to full RPM.

Any suggestions from the Wren veterans out there?

Thanks for any feedback!

Woody