RCU Forums - View Single Post - tail control
Thread: tail control
View Single Post
Old 08-27-2007 | 03:49 PM
  #12  
MMatheny
Senior Member
 
Joined: Jan 2003
Posts: 810
Likes: 0
Received 0 Likes on 0 Posts
From: Dickinson, TX
Default RE: tail control

ORIGINAL: Eric_PA

Yup, i'm talking about the main motor gear. I don't know why but it fixed my problem. Before I did this, I had full right trim and had to hold the stick to the right as well to keep it straight. After increasing the main motor gear mesh I was back at a center trim and copter holding straight.
You INCREASED the mesh - does that mean looser or tighter?
MMatheny is offline  
Reply Like