RCU Forums - View Single Post - MVVS 45 manifold
Thread: MVVS 45 manifold
View Single Post
Old 08-29-2007 | 08:31 AM
  #8  
BaldEagel's Avatar
BaldEagel
 
Joined: Oct 2005
Posts: 9,673
Received 6 Likes on 6 Posts
From: Kent, UNITED KINGDOM
Default RE: MVVS 45 manifold

ORIGINAL: DLEVETT

Hi Guys,
I just obtained a MVVS 45mg engine from Dave Moen here in Canada. I would like to run this engine in a QuiQui 86" Yak along with a MTW 75 cannister.
My question is how do I get one of the pictured headers for my engine?
We have a local modeller who makes headers, but does so out of Aluminum. I,m would like to get a Stainless steel header as it would seem to me to be stronger.

thx Dave
Dave

Afraid I don't know where in Canada you could get that done, obviously Pe could do it for you, just ask, alternativly you could just get the bits from him and have it brazed together in Canada.

Mike
BaldEagel is offline  
Reply Like