RCU Forums - View Single Post - Control Surfaces where to measure?
Thread: Control Surfaces where to measure?
View Single Post
Old 03-18-2003 | 02:23 PM
  #6  
TerrellFlyer
Senior Member
 
Joined: Mar 2002
Posts: 1,631
Likes: 0
Received 0 Likes on 0 Posts
From: Terrell, TX
Default Control Surfaces where to measure?
As Whirley Bird I use the GP gage and the throw meter from Don's Hobby Shop,most measure from the center of the surface,but as long as the controls are the same it doesn't matter.
TerrellFlyer is offline  
Reply Like