I am finishing my BobCat and I have two questions/problems:
1) The elevator servos do not travel perfectly in synch. I am using JR 3301's with a 10X transmitter programmed for dual elevator servos. I can get the center and endpoints matched up but they seem to travel at different rates, with one servo lagging in the middle then catching up. The linkage geometry is as good as I can get it. Does the Matchbox solve this? Or is this even a problem? I have used dual elevator systems before without any problems. I guess I just never noticed the difference since the elevators were farther apart.
2) I have never used a gyro, but I have heard lots of rumors lately. Which one should I buy?
Thanks for any help.