RCU Forums - View Single Post - TwinJet cutting out problem
Thread: TwinJet cutting out problem
View Single Post
Old 03-18-2003 | 10:08 PM
  #1  
Chocky
Junior Member
 
Joined: Mar 2003
Posts: 29
Likes: 0
Received 0 Likes on 0 Posts
From: Bisley, UNITED KINGDOM
Default TwinJet cutting out problem
I've recently installed two Graupner Speed 480 ball raced motors into my Twinjet. It's always run fine on a Jeti JES 350 speed controller with Speed 400 motors, but is now cutting out after a few minutes flying. I'm using a 2300maH 8cell nicad pack. Could it be an overheating issue? I'm using Cam Speed 5.5 x 5.5 props if that's an issue. Help! the weekends going to be sunny and we don't get many of them over here.

Chocky.
Chocky is offline  
Reply Like