RCU Forums - View Single Post - axe cp thread
Thread
:
axe cp thread
View Single Post
09-08-2007 | 03:07 PM
#
1555
s_mcflurry
Senior Member
Joined:
Apr 2007
Posts:
230
Likes: 0
Received 0 Likes on 0 Posts
From:
Santa Ana, CA
RE: axe cp thread
It'll drift left naturally. It's a bigger issue while it's sliding around on the floor and less so while it's hovering. Just give it a little right roll input (right stick to the right) to compensate.
Reply
Like
s_mcflurry
View Public Profile
Send a private message to s_mcflurry
Find More Posts by s_mcflurry
View iTrader Profile