Hello all,
I am currently building the Sopwith Camel 60 from Hangar 9. I am installing an OS .90FS in the supplied motor mounts in the prelocated position and notice, with the cowling on, the engine shaft is down and to the left of the center of the hub bump in the engine. The dummy engine is glued in straight with the cowl and I have relieved some material around the rocker cover area of the engine so the cowl clears the engine properly.
I have read where some others have used this engine combination and was wondering if you could share any input on this? maybe a picture?
Thanks in advance,
33LaKid