RCU Forums - View Single Post - Hangar 9 Sopwith Camel engine question
View Single Post
Old 09-18-2007 | 06:30 AM
  #3  
da Rock
Senior Member
 
Joined: Oct 2005
Posts: 11,517
Likes: 0
Received 2 Likes on 2 Posts
From: Near Pfafftown NC
Default RE: Hangar 9 Sopwith Camel engine question

roofer,
Is there anything in that HUGE thread that applies to this question? I just scanned through it and it appears that Minnflyer covered the cowl install on page 3 and it was one post that said his cowl fit perfectly. But I may have missed something about the lineup.

When anyone posts a link with nothing else, no words explaining what's in the link and why it's posted, it's not much value.

Where in that thread did you see something that applies? It's just good manners to point out what page and post number you are referring to.


For example:
I just scanned through that huge link again.
Minnflyer has one post about mounting his engine. It's post #22 on the second page of the thread. He says it mounted with no trouble. Nothing about lining up the prop shaft with the fake engine.
He appears to have one post about mounting the cowling. It's post #48 on the third page of that thread. He says it went on with no trouble. Also nothing about lining up the shaft to the fake engine.

I must have missed whatever it was in that thread that actually pertains to this thread. Any help with where in that huge thread there is something that applies?

thanks in advance