RCU Forums - View Single Post - Official HPI MT2 Thread

09-18-2007 | 06:07 PM

#15913

46u

Senior Member

My Feedback: (3)

Joined: Jan 2005

Posts: 22,095

Likes: 0

Received 0 Likes on 0 Posts

From: Macon, GA

RE: Official HPI MT2 Thread

HSN turn in till it bottoms but be careful not to over tighten just where it stops back it out 3 turns.
LSN flush
Could not find much on idle but I would say about 1mm
Got this off HPI web site.

Reply Like