I just can't make up my stinkin mind!!!! Little story first before the question! So I'm flying in my garage this afternoon and have taken up the sport of spot landing on things that you should really not be spot landing on Needless to say I went through 4 lowers, 2 uppers and an outer shaft in my stunt flying this afternoon! So here is the question at hand. Does a guy bite the bullet and move to the blade grips and after market blades or continue to burn through stock blades like my 8 month old goes through diapers. I've probably read too many posts regarding blade grips and the related blades cause it's about a 50/50 split between good and bad thus boiling down to personal opinion. Typical me if I do move to grips I gotta have the cnc micro heli version vs. the bladecx2 plastic version. With the xtreme motors in the mail and my two new DN lipos riding shotgun coupled with my fully modded lighter than stock heli I have the horsepower to whirl full cnc grips, but are the blades really all that much better? My LHS has both in stock so supply is not an issue. What to do what to do?