RCU Forums - View Single Post - How to bend wire landing gear...
Thread
:
How to bend wire landing gear...
View Single Post
10-25-2007, 02:00 PM
#
20
scratchonly
Senior Member
Join Date: Jun 2006
Location: winnipeg, MB, CANADA
Posts: 950
Likes: 0
Received 0 Likes on 0 Posts
RE: How to bend wire landing gear...
I have ground a radius in a section of my vise jaws so I'm not bending over a sharp corner. I would guess about a7/16 radius; I hold tension on the wire and tap it with a hammer. Works for me.
Reply
Like
scratchonly
View Public Profile
Send a private message to scratchonly
Find More Posts by scratchonly
View iTrader Profile