RCU Forums - View Single Post - Carf Integral trimming thread
View Single Post
Old 10-31-2007 | 05:47 PM
  #12  
67685
 
Joined: Aug 2004
Posts: 239
Received 2 Likes on 2 Posts
From: Nannestad, NORWAY
Default RE: Carf Integral trimming thread

Ok, that`s the same as i have now ... The entry is very sudden, compared to my previous models. I am used to provoke the entry and then decide which direction i want it to spinn. Now, i must "hang-on" to the direction it start to turn by itself ...

The Impact did also a nice spinn, but was hard to stop. I believe the heavy wings did contribute to this.