RCU Forums - View Single Post - Lining Up Templates on a foam wing for hotwire cutting???
Thread: Lining Up Templates on a foam wing for hotwire cutting???
View Single Post
Old 04-01-2003, 03:09 AM
  #4  
blvdbuzzard
 
Join Date: Jun 2002
Location: high deserts, CA
Posts: 3,717
Likes: 0
Received 4 Likes on 4 Posts
Default Lining Up Templates on a foam wing for hotwire cutting???
I have the Mother of all power supplies for my hot wire, 0-120v@0-25amps, it will not burn through the nails?????? Am I doing something wrong

I do the same thing with a fine pointed pen. I also have a center line on the templetes so I can line up the templete3s for wash out/in.

Dru.
blvdbuzzard is offline  
Reply Like