RCU Forums - View Single Post - Need a little help on new micro rigger project
Thread: Need a little help on new micro rigger project
View Single Post
Old 11-21-2007 | 04:17 PM
  #31  
deestingray
Member
 
Joined: Feb 2007
Posts: 73
Likes: 0
Received 0 Likes on 0 Posts
From: Brisbane, AUSTRALIA
Default RE: Need a little help on new micro rigger project
Flexdrives are a lot stronger and quieter than the uni joint, you can get a 1/8 flex setup and run a number of different props too on a drive dog.
deestingray is offline  
Reply Like