RCU Forums - View Single Post - Need a little help on new micro rigger project
Thread: Need a little help on new micro rigger project
View Single Post
Old 11-21-2007 | 05:38 PM
  #36  
mrfixitwhite
Senior Member
 
Joined: Jan 2006
Posts: 319
Likes: 0
Received 0 Likes on 0 Posts
From: , UNITED KINGDOM
Default RE: Need a little help on new micro rigger project
if your after and flex drive you can get them straight from hong kong nice an cheap! takes a bit longer for postage but heres a nice flex drive with 1/8th shaft
they sell lots of bits -i've bougt from them before and just noticed they do small aluminium octura X props
http://cgi.ebay.co.uk/Octura-OC098L-...QQcmdZViewItem
mrfixitwhite is offline  
Reply Like