People,
I have been watching this post for a bit and must confess ignorance concerning these cells. A few questions come to mind:
Can they be charged through a normal, production switch (i.e. Maxx Prod or similar) with built-in charge jack? Or, do they require a special connector for charging (assume use of a cell-pro charger)?
Do they require "balancing connectors"? What is a "balancing connector"?
If one were to build an ignition pack from VPX cells does one have to exercise any 123-specific precautions or methods while soldering to make a two-cell pack?
These cells seem to be a very good alternative to any other cells available. Thanks, in advance, for your replies.