Now that I have actually "read" the instructions (very nice of you not to just tell me to RTFI) I am finding some anomalies in the data, especially when comparing list view to graph view.
In list I have a max peak current of 2.5A, but in graph view I seeing a very noisy graph with peaks to 10.85A??? How can this be?
There are several sections in the data where the current is listed as 0.0A, which does not make any sense as even in failsafe (transmitter off) it should be holding the digital servos with some current. These last for about .5 sec.

Also the servo figures are given as a percentage. A percentage of What?
This time I actually went to the instructions FIRST, but it fails to explain what this percentage figure is relating to.

Again, any help or guidance greatly appreciated.