RCU Forums - View Single Post - Summit III for Pattern?
Thread
:
Summit III for Pattern?
View Single Post
12-09-2007 | 07:10 PM
#
5
JWyatt
Junior Member
Joined:
Oct 2004
Posts:
4
Likes: 0
Received 0 Likes on 0 Posts
From:
Loganville, GA
RE: Summit III for Pattern?
Matt,
Thanks for the reply. I was told by the previous owner that the bearings had just been replaced, and in fact, they do feel very smooth. I'll check the pipe length when I get home. Thanks again.
Bryan
Reply
Like
JWyatt
View Public Profile
Send a private message to JWyatt
Find More Posts by JWyatt
View iTrader Profile