Over Christmas I'm going to strip my Tiger again,move the switch gear from underneath,do Pz's ariel mod,turn the board over and fit the heatsink to it.

As I'll be doing it over the holidays I won't have access to my workplace to make the heatsink(I work for an engineering firm),so I could do with pre-making it ready for the big strip down.

Would one of you fine gentlemen who've already fitted a heatsink to their Tiger's board be able to fix me up with the dimensions of it please?

We've got plenty of Ally plate at work,around 2-2.5mm thick,so I'll use a piece of that,but I could do with the old width-length-height bit
so that I can get going.

mm's or inches will do.
Ta.

Miggers