RCU Forums - View Single Post - U Can Do 3D
Thread: U Can Do 3D
View Single Post
Old 12-26-2007 | 06:31 PM
  #3374  
sven311
Junior Member
 
Joined: Dec 2007
Posts: 2
Likes: 0
Received 0 Likes on 0 Posts
From: LiedekerkeVLaams-Brabant, BELGIUM
Default RE: U Can Do 3D
hello,
Uihm I will fly the UCD with an saito 100 also,but wich servo's do I need?
I prefer to buy futaba's but I don't know wich one are good(I like to buy the cheapest,best servo's for this plane)I'm only 16 and it's already expensife enough,you see..I hope I have enough with 200euro's for all the servo's and accu?Cause my budget is 700 euro's,the plane will cost 209euro's,the engine 300euro's=€200left.I hope I can have a great setup with €700.
I'm sorry for my "bad" english,I'm from Belgium and my mother language is Dutch...
Thanks

Hmm I might use the servo's as in this plane:

http://www.rcuniverse.com/magazine/a...?article_id=44
They are fine?.

sven
sven311 is offline  
Reply Like