RE: rc pulling
I would like to run in the outlaw class. I have 8, 550 size Johnson 3E3732 motors that I am dying to have a use for. I found a nice transmission setup at RC4WD that can take two motors. So it would be like 4 transmissions connected to a central shaft that goes through a 1:1 differential for the large rear mud tires. I was thinking of using a drag rail chassis for this setup. I know it would be super bad thats for sure. Funding will be the major issue for the setup. The transmissions alone cost like $130!! The motors though were only $3.50 a piece.