RCU Forums - View Single Post - New Rigger setup
View Single Post
Old 01-08-2008 | 07:16 PM
  #21  
goldendesign04
Senior Member
 
Joined: Aug 2007
Posts: 295
Likes: 0
Received 0 Likes on 0 Posts
From: Tampa, FL
Default RE: New Rigger setup

I was fairly certain that all edges were square an sharp but since you pointed them out, I went back over them an checked. Nicely square an sharp on all edges. a few passes with the hone stick confirmed it everything is as it should be; square, sharp an highly polished. Thanks though for your concern! An appreciate everyones advice an knowledge so far.
-Wayne