Was hoping flywilly or one of the current/previous Aurora owners would jump on this question...I tried last night to look at an Aurora60 print but I can't read Japanese...

I'll open my kits when I get home to see if there is any info in them?? Not sure there is...Been a while since I've looked at them so I forget...

Now I've "known" the Aurora prints were in all Japanese since I've had them...But it never really dawned on me until last night when I needed to get some information off them.... ...It's going to make building allot of fun!! I've seen others mention that little detail...But it just never really "hit home" ...

Anyone got a Japanese translator handy??

Is there some translating software out there?? I wonder if you could copy the writing into a PDF or Word document then use a program to translate it??