Alright, I am gettig ready to se tthe incedence of the wing and i am loking for advice before doing this critical step.

The directions in the plans of setting the incidence to 1/32 positive concerns me. The thing that concerns me is that 1/32 is a very small amount whereas the means to measure it is not very accurate. Just the thickness of a pencil line is 1/32 of an inch. So it seems to be very easy to get the measurement wrong.

I have a Robart inceidence meter but it measures in 1/2 degree increments. I did a calcuation of twhat the angle would be and came out to close to .4 degrees. Would it be just as accurate to level the fuselage and ust the robart meter setting the needle just under the 1/2 degree mark.

This is a step I don't want to goof up so any help is appreciated.

Thanks.