RCU Forums - View Single Post - y or y not
Thread: y or y not
View Single Post
Old 02-21-2008 | 08:49 PM
  #4  
acarter's Avatar
acarter
 
Joined: Nov 2006
Posts: 927
Likes: 0
Received 0 Likes on 0 Posts
From: schuylkill haven, PA
Default RE: y or y not
Like missleman said it depends on the plane. If it's a simple plane such as a piper cub then I'll run a y-harness. But if it's a 3d plane I'll run each servo separately for mixing capabilities.

Austin
acarter is offline  
Reply Like