RCU Forums - View Single Post - setting dual rates
Thread: setting dual rates
View Single Post
Old 02-27-2008 | 04:06 PM
  #2  
alan0899
 
Joined: Apr 2006
Posts: 2,275
Likes: 0
Received 0 Likes on 0 Posts
From: Warialda NSW, AUSTRALIA
Default RE: setting dual rates
G'day Mate,
First off, you need to set your Expo to "+" not "-", Futaba uses "-" for Expo, JR or Spektrum use "+", leave the servos plugged in & bind when ready to fly.
If I were you I would set my low rates to about 40%, or you may find it very hard to control, for the first few flights, until it is trimmed.
alan0899 is offline  
Reply Like