RCU Forums - View Single Post - Tail going counter-clock -- servo is already maxed out
Thread: Tail going counter-clock -- servo is already maxed out
View Single Post
Old 03-06-2008 | 08:24 AM
  #10  
BladeCX2Two
Senior Member
 
Joined: Aug 2007
Posts: 202
Likes: 0
Received 0 Likes on 0 Posts
From: Upper Midwest, WI
Default RE: Tail going counter-clock -- servo is already maxed out
Thanks for the reply... I haven't checked the pitch at all lately since I put on the Align blades but it very well could be off several degress. I'll post back later on today. Gotta go to work.


Thanks again.
BladeCX2Two is offline  
Reply Like