RCU Forums - View Single Post - Platt FW-190
Thread
:
Platt FW-190
View Single Post
03-16-2008, 03:44 PM
#
89
ampeater
My Feedback: (
1
)
Join Date: Jun 2005
Location: Burlington, NJ
Posts: 383
Likes: 0
Received 0 Likes on 0 Posts
RE: Platt FW-190
Thanks, Rich. It feels good finally getting close to ready for the maiden.
I knew those leftover springs from the Dewalt battery packs I broke open would come in handy. I made the gun hood latch. Push on the port MG to pop the hood open. The only downside is that the guns get in the way of taking the cowl off, so I'll have to take out the 2 screws holding the guns in to get the cowl off. Shouldn't be too much of a pain, if it is I'll put some hinges on the cowl and turn it into a clamsheel like the full scale somewhere down the road.
Attached Thumbnails
Reply
Like
ampeater
View Public Profile
Send a private message to ampeater
Find More Posts by ampeater
View iTrader Profile