RCU Forums - View Single Post - axe cp thread
View Single Post
Old 03-18-2008 | 06:57 PM
  #1826  
nscradar's Avatar
nscradar
Member
 
Joined: Sep 2007
Posts: 74
Likes: 0
Received 0 Likes on 0 Posts
From: Rigby, ID
Default RE: axe cp thread

Mark, good to see you are still around, even if its only for just a little while longer. I have to admit I took a lot of inspiration from your contributions to this forum.

Well It's time to investigate going separates. I burned up a motor this weekend at the gym. Good solid hover, then a rapid reduction in power. Just another hard landing is all. Thankfully I was only about ten feet up.

CopterX build is going real sloooow. No instructions. Hope I dont end up with spare parts, LOL.