Well I bought one finally. I have a cx2 V2 with the 3 in 1 and fuses on the motors and alum head. I bought all the cnc bits too. I havn't installed any of the cnc bits until I crash and break something which I highly doubt I will due to my experience with the axe cp. I'm not planning any xtreme mods for it either. Stock with the cnc bits no more no less. I can't believe I'm flying ways I only wish I could have with the axe. I'm doing circuits...figure 8's...backwards circles and changing direction mid flight. I'm sorry to say I'm switching over to co-axials..more stable easier to fly...less complex setting up and no tail rotor to worry about. I'm looking into the eflite jet ranger body too. My axe is up for sale in the ads and willing to trade. Make an offer.