RCU Forums - View Single Post - Echo Lathe/mill project
Thread: Echo Lathe/mill project
View Single Post
Old 04-01-2008 | 10:35 PM
  #17  
w8ye's Avatar
w8ye
My Feedback: (16)
 
Joined: Dec 2001
Posts: 37,576
Received 11 Likes on 10 Posts
From: Shelby, OH
Default RE: Echo Lathe/mill project
This thread has my blessing.

Though the engine is not actually intended for a model, this project will endure all the design pressures involved if you were in fact making an engine for a model airplane or car.

Enjoy

Jim - Moderator
w8ye is offline  
Reply Like