RCU Forums - View Single Post - Ok, almost done. Does this look right?
Thread: Ok, almost done. Does this look right?
View Single Post
Old 04-07-2008 | 11:07 AM
  #7  
ByLoudDesign's Avatar
ByLoudDesign
 
Joined: Sep 2005
Posts: 1,456
Likes: 0
Received 0 Likes on 0 Posts
From: Mesa, AZ
Default RE: Ok, almost done. Does this look right?
Bretd123
Nice job! The only thing I see is both control line tubes kink slightly as they pass into the compartment. If it was me I would move both servo so they line up with the NATURAL lay of the control(Just unhook the link and watch it move!). Again nice job!
Charlie
ByLoudDesign is offline  
Reply Like