RCU Forums - View Single Post - CF Blades required for basic 3D ?
Thread: CF Blades required for basic 3D ?
View Single Post
Old 04-23-2008 | 07:21 AM
  #14  
MiniCwik's Avatar
MiniCwik
Senior Member
 
Joined: Jan 2007
Posts: 1,035
Likes: 0
Received 0 Likes on 0 Posts
From: New Baltimore, MI
Default RE: CF Blades required for basic 3D ?

ORIGINAL: BryFlyGuy67

I did not know about the quality of those Helidirect blades, srouthouse. Thanks! I think I shall order a few sets!
Are these the same that come on the HDX? If so, they were okay ... but needed some tracking tape to balance. The Radix are pre-balanced from the factory
MiniCwik is offline  
Reply Like