RCU Forums - View Single Post - CF Blades required for basic 3D ?
View Single Post
Old 04-23-2008 | 08:34 AM
  #15  
Skarn
Senior Member
 
Joined: Jan 2007
Posts: 1,047
Likes: 0
Received 0 Likes on 0 Posts
From: Pasadena, MD
Default RE: CF Blades required for basic 3D ?


ORIGINAL: MiniCwik


ORIGINAL: BryFlyGuy67

I did not know about the quality of those Helidirect blades, srouthouse. Thanks! I think I shall order a few sets!
Are these the same that come on the HDX? If so, they were okay ... but needed some tracking tape to balance. The Radix are pre-balanced from the factory

I've never had a set of blades that were perfectly balanced from the factory including all 3 sets of Radix so far. Yes, the Radix were VERY close, but I still needed a small amount of tape. But it prob would be fine without it )

Skarn