I'm a beginning heli pilot,and have a Black Hawk 450SE(Trex clone). I fly it with a DX7 radio. I have it trimmed out,and it hovers well,but if I just give it the slightest nudge of forward cyclic,it takes off like a bat out of (you know where)[X(]! How can I "soften up" the controls for this heli. Do I go into the swash program and reduce the numbers,and do they (ail/ele/pit all have to be the same? Or go into the ATV program and cut the servo travel down? I have the exponental set on the ail/elev set at 20%+ right now. Should I increase the expo,and leave the servo travel alone? I don't have any experenced(or any heli pilots,period) in my area to help with the set up. I just want the heli to fly smooth and slow(read/not tear out like a dragster) while I'm learning,to fly FF. Also the idle up feature scares the (@$%$#) out of me.I figure sooner,or later I'm gonna hit the switch by accident. Is there any way I can program it out of the heli? I know this is allot of questions,but you guy's are about my ONLY source of information. Thanks,Ron