I have been flying rc airplanes for 25yrs, I always wanted a pt boat, but was always too busy scratch building planes. Proboat came out with their rtr pt boat and I thought that a good start to get into rc boating. If I like it I will scratch build my next boat.
The speed controller is turning out to be a mystery. One minute it wont go to full throttle, next minute, the 0 set point seems to move so that when the stick is neutral (and I run out of trim throttle tab, it still runns a little forward (and sometimes backward). There was nothing in the documentation, and proboat has not been very responsive.
I assume there is a "key" that you have to put in....i.e. push throttle all the way forward, then back, then to neutral" or something, but I cannot figure out what it is.

Any help setting this speed controller would be greatly appreciated!