Was breaking in my evolution 46nt on my PNP H9 Cub today on Power M. 15% (18% synth) She started right up and idled fine for about 5 min then died, After that it would only run breifly before dieing. I left the needles alone per the instructions. After about an hour I reset the needles 2 1/2 out on the high and 2 on the low. Of course my battery died before I could try again. I noticed toward the end of my breif run periods the engine (where I was holding on the glow driver) was getting to hot to touch before it died but it wasn't lean. Im gonna leave the tank full tonight since I dont have a manual pump. Any suggestions?

Thanks, Pete