^ exactly m8 a hell of a lot of spinning on PVC/ABS so the rpms will be very high but once you get the bite piont nailed you will be drifting at half speed it just takes a while to pick it up,throttle control is a must for drifting but everyone goes balls out on there first few runs lol
Once you find the bite piont on PVC its a lot easier i can full power my rc on pvc and it will like aquaplane forward lmao but if you use half throttle you will build up speed that way

This vid was my first run on PVC

[link=http://media.putfile.com/DRIFTER-68]http://media.putfile.com/DRIFTER-68[/link]


after a few packs they stick alot better that was running a 21turn motor putting out about 16.000rpm so im guessing your nitro has to be putting at least 35-45.000rpm [X(] so have fun hehe