RCU Forums - View Single Post - Knife edge trimming question
View Single Post
Old 05-21-2008 | 09:58 PM
  #27  
Imac Kiwi's Avatar
Imac Kiwi
Senior Member
 
Joined: Mar 2003
Posts: 321
Likes: 0
Received 0 Likes on 0 Posts
From: Tg, NEW ZEALAND
Default RE: Knife edge trimming question

Thanks Bryan for your input, there are a lot of us out here who appreciate it.

I am just putting an Integral together and will try your set-up. It makes a lot of sense and explains a lot about why my last 2M Patternship flew the way it did.