We don't have a specific number of turns for the air-bleed screw. We set it visually and go from there. If we don't know where it's set, we usually close it to make the idle at maximum rich. We then work it leaner from there.

To all: please be advised that THIS IS NOT A DISCUSSION FORUM. If you wish to post your own information or answer questions, then please do that in the general engines forum. This forum is for people to ask questions of the O.S. Service Staff and get answers from them. Do not answer other people's questions. If you have a follow-up question on the same topic as the thread starter, you may add your question. However, discussions or answers from non-O.S. Support people will be deleted.