Hi,

I done a search and did not get a return. I hope there are some older engine guru's here. I have two K&B 61's that are, I am guessing about 1980 era. Both engines are NIB, that I recieved from a friend who planned to get into RC planes, but never did. I ran one in last week and was pleased at how easy it was to get it to run well. I have heard say from folks here around my flying area, that these engines produce power close to 46 to 52 size glow engines of current production. That said I have several models I could use these two engines in.

My problem is this. The needle valve doesn't have a way of extending the thumb surface to get it out of a cowel. There is no set screw or such. It is a brass unit. How did you guys extend these needle valve thumb screws. I am thinking of two ways. 1. Braise a piece of brass onto the existing part. 2. Drilling it out to allow hooking on to it.

Any help would be much appreciated.