RCU Forums - View Single Post - both servos are going in the same direction
Thread: both servos are going in the same direction
View Single Post
Old 05-15-2003 | 12:21 PM
  #12  
cruzomatic
Senior Member
My Feedback: (17)
 
Joined: Jan 2003
Posts: 2,106
Likes: 0
Received 0 Likes on 0 Posts
From: San Antonio, TX
Default both servos are going in the same direction
Thanks guys. I'll do some troubleshooting when I get home. I do know the Flash 5 does support flaperons, but just wasn't sure how to do the setup on the rx in relation to the dual servos. I'll give it a try on channels 1/5-6 or 1/7. Check back, I'll post the results.
cruzomatic is offline  
Reply Like