RCU Forums - View Single Post - Picco .26 one-way pullstart bearing
Thread: Picco .26 one-way pullstart bearing
View Single Post
Old 05-16-2003 | 04:02 PM
  #4  
Rex2342's Avatar
Rex2342
Senior Member
 
Joined: Apr 2003
Posts: 1,835
Likes: 0
Received 0 Likes on 0 Posts
From: East Pittsburgh, PA,
Default Picco .26 one-way pullstart bearing
I wasn't sure if the pullstart was the same or not.My 8port is the same way.Ask HPI if there roto start will fit on the pico.26 then you wouldn't have to worry about a pullstart anymore.Maybe the Hyper21 8 port pullstart will fit?
Rex2342 is offline  
Reply Like