RCU Forums - View Single Post - Elevator flutter on a LASER 3D
Thread: Elevator flutter on a LASER 3D
View Single Post
Old 08-18-2008 | 08:23 PM
  #2  
rmenke
Senior Member
My Feedback: (13)
 
Joined: Jun 2004
Posts: 2,118
Likes: 0
Received 0 Likes on 0 Posts
From: Merced, Ca., CA
Default RE: Elevator flutter on a LASER 3D
DAKATOA:

Get a "robarts" type inclination meeter and check all your surfaces relationships, should be engine-0down 2-3% right, 0 wing, 0 elevator. Get used to sealing all of your control surfaces including rudder. Will help flutter conditions. In your case, seal both sides.
rmenke is offline  
Reply Like