I have an Axe CP it was running fine til the e-board fried plug it in and the smoke got out. Here is the problem I have tried two separate e-boards and it is the same with both, all servos jump and come to life they all move and all the lights come on on the board but the motors don't run both main and tail. I have put power to the motors and they both run when on independent batteries but when everything is hooked up to the board I get nothing??? Any help would be good, should I just run separates or am I missing something. I have not tried another receiver yet I am beginning to think that might be the problem not sending a signal to the e-board maybe???


Thanks