RCU Forums - View Single Post - Official HPI MT2 Thread
Thread: Official HPI MT2 Thread
View Single Post
Old 09-25-2008 | 10:36 PM
  #18057  
spoonrc
Senior Member
 
Joined: May 2006
Posts: 439
Likes: 0
Received 2 Likes on 2 Posts
From: Brisbane, AUSTRALIA
Default RE: Official HPI MT2 Thread
You guys able to help me fit this flywheel http://www3.towerhobbies.com/cgi-bin...5&I=LXESB3&P=K onto the .18TZ-TX? http://www3.towerhobbies.com/cgi-bin...5&I=LXHLV9&P=K

The collet is exactly the same in this picture, it doesnt fit over the engine end of the crank shaft http://www3.towerhobbies.com/cgi-bin...5&I=LXHLV9&P=K
spoonrc is offline  
Reply Like